Jl-audio Stealthbox SB-GM-CLRDO/10W3v3/DG2 Manuel d'utilisateur télécharger pdf (Page 2)

➔

STEP 7:

(A) Thread the supplied socket cup

screw into the Stealthbox.Leave 1/2”exposed.

(B) Place the Stealthbox into position and line

up the curved corners of the Stealthbox, that

are between the woofer and the square shape

of the Stealthbox.These corners need to line

up with the curvature of the transmission

hump floor as it goes to the rear and jets to

the right and left of the truck. Once into place,

push down with force.

(C)With a 1/2” drill bit, drill at the impression that

was left by the Stealthbox in STEP6.

Cont.

From

Page

Continued on Next Page ➔

➔

STEALTHBOX WALL

THREADED INSERT

VEHICLE SHEET METAL

FENDER WASHER

SOCKET CUP SET SCREW

LOCK WASHER

FLAT WASHER

HEX NUT

STEP 8: With the drilled out hole in the floor.

Expose the socket cup set screw 2” out of the

Stealthbox.Place the Stealthbox into position and

guide the socket cup set screw through the drilled

hole.

From under the vehicle, place the supplied fender

washer, flat washer, lock washer and hex nut onto

the socket cup screw.

STEP 9: Place the jack back into the holder and

then place the jack assembly to the floor(same area

it was removed from) with the yellow knob facing

the passenger’s side rear door.With one factory

mounting bolt. Secure the assembly with to the dri-

ver’s side mounting threads. Use the second factory

mounting bolt to plug up the passenger’s side

mounting threads.

STEP10: With a second person, place the rear

seat back into position.Wrap the shoulder belt in

front of the seat and through bottom crease of the

seat.

SB-GM-CLDRO/10W3v3, JL AUDIO, Inc 2006

Sheet SKU#011189 Revision 3/8/2006Page 2

www.jlaudio.com

*CAUTION*

Before drilling, make sure that you are not going to be

drilling into any gas lines, brake lines, transmission lines,

electrical wiring, transfer case(4x4 vehicles) or anything

else that might cause a reduction in your weekly pay.

Always wear eye protection when drilling.

With the use of a 1/2” drill bit and drill. Drill out the

floor at the impression on the wax square.

After the hole is drilled, remove the wax square

➔

1 2 3

Commentaires sur ces manuels

Pas de commentaire

Jl-audio Stealthbox SB-GM-CLRDO/10W3v3/DG2 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Haut-parleurs pour voitures Jl-audio Stealthbox SB-GM-CLRDO/10W3v3/DG2